top of page

The Engine

This view shows my redesigned redrive mount. the plate that the engine is mounted on is attached to two angles on the side of the engine. The darkest hexagonal piece is a temporary rubber gasket where the starter will go. Muffler attachment will happen after the floor pan is installed.

The pull starter assembly against the firewall will be removed later. the carbuerator port is plugged with desiccant and a paper towel for now. belts will go on after all is done, and the prop will follow belt installation.

Note the through-bolted shock absorbtion at the engine plate.

The pull starter assembly against the firewall will be removed later. the carbuerator port is plugged with desiccant and a paper towel for now. belts will go on after all is done, and the prop will follow belt installation.

Note the through-bolted shock absorbtion at the engine plate.

  • w-facebook
  • Twitter Clean
  • w-flickr
bottom of page